Grease Trap Requirements
Concord, NC
FOG compliance regulations for food service establishments in Concord, North Carolina.
FOG Compliance in Concord, NC
Food service establishments in Concord operate under a combination of federal EPA pretreatment standards, North Carolina state plumbing code, and city-level FOG ordinances. Together these rules determine how grease traps must be sized, how often they must be pumped, and what happens when a restaurant falls out of compliance.
Pumping frequency is the compliance rule restaurant owners interact with most often. In Concord, the rule is: Every 90 days or when 25% full. This aligns with the 90-day US median enforced by most major cities. The city follows the Uniform Plumbing Code (UPC) for trap sizing and installation. Under Section 1014, which applies a fixture drainage load formula with a retention time factor, grease interceptors installed in Concord must meet minimum capacity thresholds based on the fixtures connected to them — 3-compartment sinks, dishwashers, pre-rinse stations, wok stoves, and floor drains on the cook line.
Concord requires a dedicated FOG permit for any food service establishment generating fats, oils, and grease. The permit is separate from, and in addition to, the plumbing permit required at installation.
Concord enforces the 25 percent rule: grease traps must be pumped before the combined FOG and settled solids reach 25 percent of the trap's total liquid depth. Inspectors measure the depth with a sludge judge or dipstick, typically at surprise visits. Exceeding the threshold at inspection triggers a notice of violation and mandatory emergency pump-out, regardless of the scheduled pumping cycle. Establishments must maintain pumping logs, hauler manifests, and inspection reports on-site — missing records is itself a violation in most enforcement actions. Enforcement authority rests with the City of Concord Wastewater Department, FOG Control Program, which handles permit issuance, inspections, and hauler licensing.
For a deeper explanation of the rules this city enforces, read our guides on how grease traps work and the 25/50 pumping rule.
Pumping Requirements
Permits & Enforcement
Complete FOG Regulations
| Pumping Frequency | Every 90 days or when 25% full |
|---|---|
| 25% Rule | Yes — trap must be pumped when grease and solids reach 25% of capacity |
| Permit Required | Yes |
| Record Keeping | Required — maintain pumping logs and manifests on-site |
| Plumbing Code | Uniform Plumbing Code (UPC) |
| Ordinance Ref. | Section 802.3.3; Section 1001; Chapter 10; Section 1002 |
| Authority | City of Concord Wastewater Department, FOG Control Program |
Additional Notes
Automatic Grease Removal Units (AGRU) mentioned as option. FOG Control Program targets commercial food service establishments. AGRUs accepted as alternative.
Last verified: — Regulations change frequently. Always verify current requirements with your local wastewater authority or plumbing inspector before making compliance decisions.
Contact Information
(704) 920-5353
Official Sources
Size Your Grease Trap for Concord
Our free calculator uses UPC code requirements to recommend the right size.
Open CalculatorOther Cities in North Carolina
Every 60 days; FSEs may apply for Service Variance...
CharlotteAt minimum every 90 days; must be pumped before FO...
Durhamweekly...
FayettevilleEvery 60 days maximum for grease traps; daily or p...
GreensboroQuarterly (every 90 days minimum) or when 25% full...
Harrisburgquarterly...
KannapolisAnnual...
RaleighMinimum every 90 days (quarterly). Must be pumped ...