Grease Trap Requirements
Virginia Beach, VA

FOG Compliance in Virginia Beach, VA

Food service establishments in Virginia Beach operate under a combination of federal EPA pretreatment standards, Virginia state plumbing code, and city-level FOG ordinances. Together these rules determine how grease traps must be sized, how often they must be pumped, and what happens when a restaurant falls out of compliance. The city has approximately 1,241 food service establishments — every one of them subject to the rules summarized below.

Pumping frequency is the compliance rule restaurant owners interact with most often. In Virginia Beach, the rule is: Annual. This is more lenient than the US median, typical of jurisdictions with lower-volume food service sectors. The city follows the International Plumbing Code (IPC) for trap sizing and installation. Under Section 1003.3.4, which sizes traps by drainage fixture unit counts, grease interceptors installed in Virginia Beach must meet minimum capacity thresholds based on the fixtures connected to them — 3-compartment sinks, dishwashers, pre-rinse stations, wok stoves, and floor drains on the cook line. The local minimum trap size is: 1,000 gallons.

Virginia Beach requires a dedicated FOG permit for any food service establishment generating fats, oils, and grease. The permit is separate from, and in addition to, the plumbing permit required at installation.

Virginia Beach enforces the 25 percent rule: grease traps must be pumped before the combined FOG and settled solids reach 25 percent of the trap's total liquid depth. Inspectors measure the depth with a sludge judge or dipstick, typically at surprise visits. Exceeding the threshold at inspection triggers a notice of violation and mandatory emergency pump-out, regardless of the scheduled pumping cycle. Establishments must maintain pumping logs, hauler manifests, and inspection reports on-site — missing records is itself a violation in most enforcement actions. Enforcement authority rests with the Virginia Beach Public Utilities, Conservation and Education, which handles permit issuance, inspections, and hauler licensing.

For a deeper explanation of the rules this city enforces, read our guides on how grease traps work and the 25/50 pumping rule.