Grease Trap Requirements
Henderson, NV
FOG compliance regulations for food service establishments in Henderson, Nevada.
FOG Compliance in Henderson, NV
Food service establishments in Henderson operate under a combination of federal EPA pretreatment standards, Nevada state plumbing code, and city-level FOG ordinances. Together these rules determine how grease traps must be sized, how often they must be pumped, and what happens when a restaurant falls out of compliance.
Pumping frequency is the compliance rule restaurant owners interact with most often. In Henderson, the rule is: As needed per maintenance program. This aligns with the 90-day US median enforced by most major cities. The city follows the Uniform Plumbing Code (UPC) for trap sizing and installation. Under Section 1014, which applies a fixture drainage load formula with a retention time factor, grease interceptors installed in Henderson must meet minimum capacity thresholds based on the fixtures connected to them — 3-compartment sinks, dishwashers, pre-rinse stations, wok stoves, and floor drains on the cook line. The local minimum trap size is: Per UPC Chapter 10 requirements; sized per fixture unit load.
Henderson requires a dedicated FOG permit for any food service establishment generating fats, oils, and grease. The annual permit fee is Waste Discharge Authorization Application required; contact Pretreatment at 702-267-2603. The permit is separate from, and in addition to, the plumbing permit required at installation. Violations carry maximum penalties of Per Henderson Municipal Code enforcement provisions . Fines typically escalate with repeat violations, and severe discharges that cause sanitary sewer overflows can trigger federal Clean Water Act penalties layered on top of local fines.
Henderson enforces the 25 percent rule: grease traps must be pumped before the combined FOG and settled solids reach 25 percent of the trap's total liquid depth. Inspectors measure the depth with a sludge judge or dipstick, typically at surprise visits. Exceeding the threshold at inspection triggers a notice of violation and mandatory emergency pump-out, regardless of the scheduled pumping cycle. Periodic inspections by city Pretreatment staff. Establishments must maintain pumping logs, hauler manifests, and inspection reports on-site — missing records is itself a violation in most enforcement actions. Enforcement authority rests with the City of Henderson Utility Services – Pretreatment Division, which handles permit issuance, inspections, and hauler licensing.
For a deeper explanation of the rules this city enforces, read our guides on how grease traps work and the 25/50 pumping rule.
Pumping Requirements
Permits & Enforcement
Complete FOG Regulations
| Minimum Trap Size | Per UPC Chapter 10 requirements; sized per fixture unit load |
|---|---|
| Pumping Frequency | As needed per maintenance program; must maintain interceptor efficiency |
| 25% Rule | Yes — trap must be pumped when grease and solids reach 25% of capacity |
| Permit Required | Yes |
| Permit Fee | Waste Discharge Authorization Application required; contact Pretreatment at 702-267-2603 |
| Maximum Fine | Per Henderson Municipal Code enforcement provisions |
| Inspections | Periodic inspections by city Pretreatment staff |
| Record Keeping | Required — maintain pumping logs and manifests on-site |
| Plumbing Code | Uniform Plumbing Code (UPC) |
| Ordinance Ref. | Henderson Municipal Code Chapter 14.09 – Pretreatment Regulations; Chapter 15.20 UPC |
| Authority | City of Henderson Utility Services – Pretreatment Division |
Additional Notes
Maintenance records must be kept on premises at all times. Commercial FSEs including restaurants, cafes, cafeterias, supermarkets, bakeries, hospitals, school kitchens must install interceptors. Audio/visual alarms required per UPC.
Last verified: — Regulations change frequently. Always verify current requirements with your local wastewater authority or plumbing inspector before making compliance decisions.
Size Your Grease Trap for Henderson
Our free calculator uses UPC code requirements to recommend the right size.
Open Calculator