Grease Trap Requirements
Roseville, CA
FOG compliance regulations for food service establishments in Roseville, California.
FOG Compliance in Roseville, CA
Food service establishments in Roseville operate under a combination of federal EPA pretreatment standards, California state plumbing code, and city-level FOG ordinances. Together these rules determine how grease traps must be sized, how often they must be pumped, and what happens when a restaurant falls out of compliance.
Pumping frequency is the compliance rule restaurant owners interact with most often. In Roseville, the rule is: Every 90 days minimum, or per 25% rule, whichever is more frequent. This aligns with the 90-day US median enforced by most major cities. The city follows the Uniform Plumbing Code (UPC) for trap sizing and installation. Under Section 1014, which applies a fixture drainage load formula with a retention time factor, grease interceptors installed in Roseville must meet minimum capacity thresholds based on the fixtures connected to them — 3-compartment sinks, dishwashers, pre-rinse stations, wok stoves, and floor drains on the cook line. The local minimum trap size is: 1,000 gallons minimum for new FSE construction.
Roseville requires a dedicated FOG permit for any food service establishment generating fats, oils, and grease. The annual permit fee is Set by city council resolution; annual grease disposal mitigation fee may apply if no interceptor installed. The permit is separate from, and in addition to, the plumbing permit required at installation. Violations carry maximum penalties of Unknown - enforcement actions per FOG Wastewater Discharge Permit terms . Fines typically escalate with repeat violations, and severe discharges that cause sanitary sewer overflows can trigger federal Clean Water Act penalties layered on top of local fines.
Roseville enforces the 25 percent rule: grease traps must be pumped before the combined FOG and settled solids reach 25 percent of the trap's total liquid depth. Inspectors measure the depth with a sludge judge or dipstick, typically at surprise visits. Exceeding the threshold at inspection triggers a notice of violation and mandatory emergency pump-out, regardless of the scheduled pumping cycle. As determined by permit conditions; city conducts periodic compliance inspections. Establishments must maintain pumping logs, hauler manifests, and inspection reports on-site — missing records is itself a violation in most enforcement actions. Enforcement authority rests with the City of Roseville Environmental Utilities Department, which handles permit issuance, inspections, and hauler licensing.
For a deeper explanation of the rules this city enforces, read our guides on how grease traps work and the 25/50 pumping rule.
Pumping Requirements
Permits & Enforcement
Complete FOG Regulations
| Minimum Trap Size | 1,000 gallons minimum for new FSE construction |
|---|---|
| Pumping Frequency | Every 90 days minimum, or per 25% rule, whichever is more frequent |
| 25% Rule | Yes — trap must be pumped when grease and solids reach 25% of capacity |
| Permit Required | Yes |
| Permit Fee | Set by city council resolution; annual grease disposal mitigation fee may apply if no interceptor installed |
| Maximum Fine | Unknown - enforcement actions per FOG Wastewater Discharge Permit terms |
| Inspections | As determined by permit conditions; city conducts periodic compliance inspections |
| Record Keeping | Required — maintain pumping logs and manifests on-site |
| Plumbing Code | Uniform Plumbing Code (UPC) |
| Ordinance Ref. | Roseville Municipal Code Title 8, Chapter 802 (FOG Ordinance) |
| Authority | City of Roseville Environmental Utilities Department |
Additional Notes
FOG Wastewater Discharge Permit (WDP) required for all FSEs. Waiver from interceptor installation possible but FSE may need to reserve space for future installation. Digital FOG compliance reporting system available.
Last verified: — Regulations change frequently. Always verify current requirements with your local wastewater authority or plumbing inspector before making compliance decisions.
Size Your Grease Trap for Roseville
Our free calculator uses UPC code requirements to recommend the right size.
Open CalculatorOther Cities in California
annual; or when grease/solids reach 25% of capacit...
CovinaAs needed to prevent FOG accumulation from exceedi...
CypressPer UPC requirements; typically every 90 days or w...
FresnoGrease traps every 90 days or when 25% rule trigge...
Huntington BeachMonthly for hydromechanical units; every 90 days f...
LancasterEvery 6 month(s); or when grease/solids reach 25% ...
Los AngelesMinimum every 90 days; more frequently if 25% grea...