Grease Trap Requirements
Riverbank, CA

FOG compliance regulations for food service establishments in Riverbank, California.

FOG Compliance in Riverbank, CA

Food service establishments in Riverbank operate under a combination of federal EPA pretreatment standards, California state plumbing code, and city-level FOG ordinances. Together these rules determine how grease traps must be sized, how often they must be pumped, and what happens when a restaurant falls out of compliance.

Pumping frequency is the compliance rule restaurant owners interact with most often. In Riverbank, the rule is: Per FOG program requirements. This aligns with the 90-day US median enforced by most major cities. The city follows the Uniform Plumbing Code (UPC) for trap sizing and installation. Under Section 1014, which applies a fixture drainage load formula with a retention time factor, grease interceptors installed in Riverbank must meet minimum capacity thresholds based on the fixtures connected to them — 3-compartment sinks, dishwashers, pre-rinse stations, wok stoves, and floor drains on the cook line.

Riverbank requires a dedicated FOG permit for any food service establishment generating fats, oils, and grease. The permit is separate from, and in addition to, the plumbing permit required at installation.

Riverbank enforces the 25 percent rule: grease traps must be pumped before the combined FOG and settled solids reach 25 percent of the trap's total liquid depth. Inspectors measure the depth with a sludge judge or dipstick, typically at surprise visits. Exceeding the threshold at inspection triggers a notice of violation and mandatory emergency pump-out, regardless of the scheduled pumping cycle. Establishments must maintain pumping logs, hauler manifests, and inspection reports on-site — missing records is itself a violation in most enforcement actions. Enforcement authority rests with the City of Riverbank Public Works, FOG Program, which handles permit issuance, inspections, and hauler licensing.

For a deeper explanation of the rules this city enforces, read our guides on how grease traps work and the 25/50 pumping rule.

Per FOG program requirements
Pumping Freq.
Required
Permit
Yes
25% Rule
UPC
Code Base

Pumping Requirements

Frequency Per FOG program requirements; typically every 90 days
25% Rule Applies

Permits & Enforcement

Permit Required Required

Complete FOG Regulations

Pumping Frequency Per FOG program requirements; typically every 90 days
25% Rule Yes — trap must be pumped when grease and solids reach 25% of capacity
Permit Required Yes
Record Keeping Required — maintain pumping logs and manifests on-site
Plumbing Code Uniform Plumbing Code (UPC)
Ordinance Ref. Chapter 10
Authority City of Riverbank Public Works, FOG Program

Additional Notes

Active FOG program. California Plumbing Code Chapter 10 applies.

Last verified: — Regulations change frequently. Always verify current requirements with your local wastewater authority or plumbing inspector before making compliance decisions.

Contact Information

Phone (209) 869-7128

City of Riverbank: (209) 869-7128

Official Sources

Size Your Grease Trap for Riverbank

Our free calculator uses UPC code requirements to recommend the right size.

Open Calculator

Other Cities in California

Benicia Brentwood

annual; or when grease/solids reach 25% of capacit...

Covina

As needed to prevent FOG accumulation from exceedi...

Cypress

Per UPC requirements; typically every 90 days or w...

Fresno

Grease traps every 90 days or when 25% rule trigge...

Huntington Beach

Monthly for hydromechanical units; every 90 days f...

Lancaster

Every 6 month(s); or when grease/solids reach 25% ...

Los Angeles

Minimum every 90 days; more frequently if 25% grea...