Grease Trap Requirements
Palmdale, CA

FOG compliance regulations for food service establishments in Palmdale, California.

FOG Compliance in Palmdale, CA

Food service establishments in Palmdale operate under a combination of federal EPA pretreatment standards, California state plumbing code, and city-level FOG ordinances. Together these rules determine how grease traps must be sized, how often they must be pumped, and what happens when a restaurant falls out of compliance.

Pumping frequency is the compliance rule restaurant owners interact with most often. In Palmdale, the rule is: Minimum every 6 months. This aligns with the 90-day US median enforced by most major cities. The city follows the Uniform Plumbing Code (UPC) for trap sizing and installation. Under Section 1014, which applies a fixture drainage load formula with a retention time factor, grease interceptors installed in Palmdale must meet minimum capacity thresholds based on the fixtures connected to them — 3-compartment sinks, dishwashers, pre-rinse stations, wok stoves, and floor drains on the cook line. The local minimum trap size is: Minimum 750 gallons (per LA County standards); 30-minute detention time required.

Palmdale requires a dedicated FOG permit for any food service establishment generating fats, oils, and grease. The annual permit fee is Unknown - contact LA County Dept of Public Works Palmdale office at (661) 947-4151. The permit is separate from, and in addition to, the plumbing permit required at installation. Violations carry maximum penalties of Unknown - per LA County Sanitation Districts enforcement . Fines typically escalate with repeat violations, and severe discharges that cause sanitary sewer overflows can trigger federal Clean Water Act penalties layered on top of local fines.

Palmdale enforces the 25 percent rule: grease traps must be pumped before the combined FOG and settled solids reach 25 percent of the trap's total liquid depth. Inspectors measure the depth with a sludge judge or dipstick, typically at surprise visits. Exceeding the threshold at inspection triggers a notice of violation and mandatory emergency pump-out, regardless of the scheduled pumping cycle. Periodic per LA County Sanitation Districts and city oversight. Establishments must maintain pumping logs, hauler manifests, and inspection reports on-site — missing records is itself a violation in most enforcement actions. Enforcement authority rests with the City of Palmdale / LA County Sanitation District No. 20 (majority) and No. 14 (small portion) / LA County Dept of Public Works, which handles permit issuance, inspections, and hauler licensing.

For a deeper explanation of the rules this city enforces, read our guides on how grease traps work and the 25/50 pumping rule.

Minimum every 6 months
Pumping Freq.
Required
Permit
Yes
25% Rule
UPC
Code Base

Pumping Requirements

Frequency Minimum every 6 months; per 25% rule if sooner
25% Rule Applies

Permits & Enforcement

Permit Required Required
Permit Fee Unknown - contact LA County Dept of Public Works Palmdale office at (661) 947-4151
Max Fine Unknown - per LA County Sanitation Districts enforcement

Complete FOG Regulations

Minimum Trap Size Minimum 750 gallons (per LA County standards); 30-minute detention time required
Pumping Frequency Minimum every 6 months; per 25% rule if sooner
25% Rule Yes — trap must be pumped when grease and solids reach 25% of capacity
Permit Required Yes
Permit Fee Unknown - contact LA County Dept of Public Works Palmdale office at (661) 947-4151
Maximum Fine Unknown - per LA County Sanitation Districts enforcement
Inspections Periodic per LA County Sanitation Districts and city oversight
Record Keeping Required — maintain pumping logs and manifests on-site
Plumbing Code Uniform Plumbing Code (UPC)
Ordinance Ref. LA County FOG Ordinance; Palmdale Municipal Code (Industrial Waste Program); LA County Sanitation Districts Rules and Regulations
Authority City of Palmdale / LA County Sanitation District No. 20 (majority) and No. 14 (small portion) / LA County Dept of Public Works

Additional Notes

Served by two sanitation districts: District 20 (majority) and District 14 (small portion). Interceptors must be properly baffled with minimum two compartments. Industrial Wastewater Discharge Permit required for regulation of industrial wastewater dischargers.

Last verified: — Regulations change frequently. Always verify current requirements with your local wastewater authority or plumbing inspector before making compliance decisions.

Size Your Grease Trap for Palmdale

Our free calculator uses UPC code requirements to recommend the right size.

Open Calculator

Other Cities in California

Benicia Brentwood

annual; or when grease/solids reach 25% of capacit...

Covina

As needed to prevent FOG accumulation from exceedi...

Cypress

Per UPC requirements; typically every 90 days or w...

Fresno

Grease traps every 90 days or when 25% rule trigge...

Huntington Beach

Monthly for hydromechanical units; every 90 days f...

Lancaster

Every 6 month(s); or when grease/solids reach 25% ...

Los Angeles

Minimum every 90 days; more frequently if 25% grea...