Phoenix vs Miami
Side-by-side FOG compliance comparison between Phoenix, AZ and Miami, FL.
| Requirement | Phoenix, AZ | Miami, FL |
|---|---|---|
| Plumbing Code | UPC (Arizona adopts UPC statewide) | IPC (Florida Building Code, which is based on the International codes) |
| Min. Trap Size | Gravity grease interceptors minimum 750 gallons for food service establishments; sizing per Phoenix City Code and Arizona Plumbing Code based on fixture count and flow rate; point-of-use interceptors minimum 20 GPM | Gravity grease interceptors: minimum 750-1,000 gallons depending on establishment size and fixture count. Hydromechanical grease interceptors (HGIs/under-sink): rated per GPM of connected fixtures per Florida Building Code. Sizing determined per FOG Control Device Guidance Manual formulas. |
| Pumping Frequency | Every 90 days minimum; more frequently if grease accumulation exceeds 25% of capacity | As specified in FOG permit conditions; typically every 30-90 days depending on establishment volume. Must be pumped before grease and solids accumulate to 25% of the wetted depth of the interceptor. |
| 25% Rule | Yes | Yes |
| Permit Required | Required | Required |
| Permit Fee | Industrial pretreatment/FOG permit required; registration fees typically $50-$150 annually | Initial FOG-1 permit application fee approximately $200; annual renewal fee approximately $65. Fees subject to update per Miami-Dade fee schedule. |
| Max Fine | $2,500 per violation per day under Phoenix City Code; administrative penalties may also apply | Up to $15,000 per day per violation under Miami-Dade County Code. Civil penalties and administrative enforcement actions including cease-and-desist orders. |
| Inspections | City of Phoenix Environmental Services Division inspects FSEs; frequency varies, typically annually for permitted facilities | Inspections conducted by Miami-Dade Water and Sewer Department (WASD) on a routine basis; typically annually for compliant FSEs, more frequently for high-risk or non-compliant establishments. Unannounced inspections authorized. |
| Record Keeping | Yes | Yes |
| Authority | City of Phoenix Water Services Department, Environmental Services Division | Miami-Dade County Water and Sewer Department (WASD), Environmental Compliance Section; Miami-Dade Permitting and Inspection Center |
| Establishments | 8,992 | 6,089 |
Key Differences
As cities in different states, Phoenix (AZ) and Miami (FL) operate under distinct regulatory frameworks. Here are the most important differences restaurant operators should know:
- Phoenix follows the Uniform Plumbing Code (UPC), while Miami uses the Uniform Plumbing Code (UPC). This affects trap sizing calculations and installation standards.
- Pumping schedules differ: Phoenix requires "Every 90 days minimum", whereas Miami requires "As specified in FOG permit conditions".
- Both cities enforce the 25% rule, requiring grease traps to be pumped when grease and solids reach 25% of the trap's capacity.
- Fines differ: Phoenix penalties can reach $2,500 per violation per day under Phoenix City Code; administrative penalties may also apply, compared to Up to $15,000 per day per violation under Miami-Dade County Code. Civil penalties and administrative enforcement actions including cease-and-desist orders. in Miami.
What This Means for Restaurant Operators
If you operate food service establishments in either city, understanding these regulatory differences is critical for compliance. Permit requirements vary, so check with each city's wastewater authority before opening a new location. Different plumbing codes (UPC (Arizona adopts UPC statewide) vs IPC (Florida Building Code, which is based on the International codes)) mean trap sizing calculations may produce different results for the same kitchen setup. Always verify current requirements directly with your local wastewater authority or plumbing inspector.
Frequently Asked Questions
How do grease trap requirements compare between Phoenix and Miami?
Phoenix follows the Uniform Plumbing Code (UPC), while Miami uses the Uniform Plumbing Code (UPC). This affects trap sizing calculations and installation standards. Pumping schedules differ: Phoenix requires "Every 90 days minimum", whereas Miami requires "As specified in FOG permit conditions".
Which city has stricter grease trap enforcement, Phoenix or Miami?
Enforcement varies: both cities have similar permit requirements. Phoenix fines: $2,500 per violation per day under Phoenix City Code; administrative penalties may also apply. Miami fines: Up to $15,000 per day per violation under Miami-Dade County Code. Civil penalties and administrative enforcement actions including cease-and-desist orders.. Always verify with local authorities.
How do pumping schedules differ between Phoenix and Miami?
Phoenix: Every 90 days minimum; more frequently if grease accumulation exceeds 25% of capacity. Miami: As specified in FOG permit conditions; typically every 30-90 days depending on establishment volume. Must be pumped befo.
Regulations change frequently. Always verify current requirements with your local wastewater authority or plumbing inspector before making compliance decisions. Last updated: March 2026.
Operating in Both Cities?
Use our sizing calculator to find the right grease trap for each location.
Open Calculator